How can I learn more about Design for Manufacturing?

There are a number of courses offered by the MIT Mechanical Engineering department that thoroughly covers design for manufacturing (DFM) and design for assembly (DFA) or both (DFM/A).

You may also consider checking out Scott Miller's Design for Manufacturing course, which is documented in a series of posts on the Dragon Innovation blog.

Was this article helpful?
0 out of 0 found this helpful



This website and all posts and content are intended for educational purposes only and for no other purposes including without limitation commercial purposes. Any other use must give proper attribution to the Martin Trust Center and is subject to certain legal rights contained in our license and terms of use. See full legal disclaimer HERE.

The content in this knowledgebase is subject to a non-exclusive license with share-alike restrictions and the terms of use of this site – which is available for your review HERE.
Have more questions? Submit a request

Comments