There are a number of courses offered by the MIT Mechanical Engineering department that thoroughly covers design for manufacturing (DFM) and design for assembly (DFA) or both (DFM/A).
You may also consider checking out Scott Miller's Design for Manufacturing course, which is documented in a series of posts on the Dragon Innovation blog.
Please sign in to leave a comment.
This website and all posts and content are intended for educational purposes only and for no
other purposes including without limitation commercial purposes. Any other use must give proper
attribution to the Martin Trust Center and is subject to certain legal rights contained in our
license and terms of use. See full legal disclaimer
HERE
.
The content in this knowledgebase is subject to a non-exclusive license with share-alike
restrictions and the terms of use of this site – which is available for your review
HERE
.
Comments
0 comments